Aluminum scrap normally contains iron particles if not removed may lead to increase in iron content in the melt which is not desirable different capacities and sizes are available on request.
Special Features
The bailing press shall be a Top filling type, with individual solenoid control valves for each ram movement.
After the loose scrap is filled in the chamber the first solenoid coil will actuate the top Cylinder which would bring down the Hinge lid and exercise the First Pressure and take down the scrap to 15 ” size.
After this the 2 nd Cylinder ( Length wise) will actuate and start pushing the first compressed scrap till the length reaches 15 ” size.
Side cylinder will compress the material to its final size.
The bottom cylinder will move upward to eject the bale from the chamber.
All the hydraulic components & valves will be internationally reputed make i.e.Yuken/ Polyhydron/ or equivalent make for trouble free & smooth operation of the press.
All the hydraulic valves will be mounted on specially designed manifold block to decrease the piping lines, it further reduces chances of any leakage during operation of the press.
Fabricated design, Stress Relieved, Auto Cad designed for low deflections, Quality M.S. steel Plates used for fabrication.
Cylinder manufactured out of ultrasonically tested high quality steel.